Example - Clifford SuperNova II Owner's Manual

# of
Factory
Feature momentary
setting
presses
Add a new
remote to
channel 2
12
—
(optional
remote
accessory)
Add a new
remote to
channel 3 13
—
(silent
arm/disarm)
Add a new
remote to
channel 4
14
—
(optional
remote
accessory)
Erase all
15
—
channels
Valet code
See Setting your own secret valet code on page 12.
Set channel
17
30sec.
4 timer
WARNING: If the built-in timer controls window/sunroof closure on your vehicle,
DO NOT change the timer setting! This requires installer-only programming.
Example : To change the AutoArming feature from its factory
setting of "on" to "off," you would do the following:
Turn the ignition key to the ON position.
Enter your valet code, then immediately tap and release the
momentary side of the PlainView switch 4 times (you'll hear a chirp
each time you press to help you count to the total of 4 chirps).
Wait 3 seconds. The system will sound one more chirp to confirm
that the AutoArming setting is now off (1 chirp = off, 2 chirps = on).
Turn the ignition off. That's all there is to it! To change the
AutoArming setting back, just repeat the procedure.
Secondary
completion
action
confirmation
Press remote control button 2
Press remote control button 3
Press remote control button 4
of the optional
4-button/12-channel ACG
remote control
—
When the desired interval has
passed, turn off the ignition key
18
Program
Result
Button 2/channel 2 code
2 chirps of the new remote control
has been memorized
Button 3/channel 3 code of
3 chirps the new remote control
has been memorized
Button 4/channel 4 code
4 chirps of the new remote control
has been memorized
All remote control codes
2 chirps have been erased; program
in new remote control(s)
Timer has been set to the
1 chirp interval of your choice
between 1sec. and 2min.