User-Selectable Features; Programming Table For User-Selectable Features - Clifford SuperNova II Owner's Manual

Clifford owner's manual world-class auto security supernova ii

Hide thumbs Also See for SuperNova II:

Owner's manual (31 pages)

Table Of Contents

Table of Contents

Your SuperNova II allows you to set many of its features to your own personal

preferences. We have made the programming procedures very simple: to make a

change, you just press the PlainView switch a few times. The system comes from

the factory with all of its features pre-programmed as noted in the table below and

on the next page. To change any of the settings, use the following procedure. To

restore the feature to its factory setting, just repeat the procedure:

1. Select the feature you wish to program from the table below and on the following

page. Note the number of momentary (spring-loaded) presses.

2. Turn your vehicle's ignition switch to its "ON" position.

3. Enter your valet code (see page 11) on the PlainView switch.

4. When the LED turns on, immediately press and release the momentary side of

the switch the number of times indicated in the third column of the programming

table for the feature you selected (to help you count, you will hear a single chirp

confirmation each time you press the momentary side).

a. If noted, perform the "Secondary action."

5. Wait 3 seconds. You will hear 1-4 chirps (as noted in the "Program completion

confirmation" column) and the LED will turn off. Turn the ignition off.

6. Repeat steps 1-5 for any other features you wish to program.

Programming table for user-selectable features

# of

Factory

Feature

momentary

setting

presses

AutoArming

AutoArm

OFF

& Lock

FACT

AutoLock

AutoUnLock

Chirp

confirmation

Siren

30 sec.

duration

Add a new

remote to

—

channel 1

(arm/disarm)