Lan; Ipv4 - D-Link DIR-842 User Manual

DIR-842 AC1200 Wave 2 MU-MIMO Wi-Fi Gigabit Router
User Manual

LAN

To configure the router's local interface, go to the Connections Setup / LAN page.

IPv4

Go to the IPv4 tab to change IPv4 address, configure the built-in DHCP server, or specify MAC
address and IP address pairs.
Figure 79. Configuring the local interface. The IPv4 tab. The Local IP Address section.
Parameter
Mode of local IP
address assignment
IP address
Mask
Gateway IP address
Hostname
Local IP Address
Available if the Access point, Repeater, or Client mode was
selected in the Setup Wizard.
Select the needed value from the drop-down list.
Static: The IPv4 address, subnet mask, and the gateway IP
•
address are assigned manually.
Dynamic: The
•
parameters from the LAN DHCP server or from the router to
which it connects.
The IPv4 address of the router in the local subnet. By default, the
following value is specified: 192.168.0.1.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Available if the Access point, Repeater, or Client mode was
selected in the Setup Wizard.
The gateway IPv4 address which is used by the router to connect to
the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
The name of the device assigned to its IP address in the local subnet.
Page 98 of 210
Configuring via Web-based Interface
Description
router automatically obtains these