Table of Contents
Advertisement
# of
Factory
Feature
momentary
setting
presses
FACT —
False Alarm
12
ON
Control and
Test
Add a New
Remote to
13
—
Channel 1
(arm/disarm)
Add a New
Remote to
Channel 2
14
—
(optional
remote
accessory)
Add a New
Remote to
Channel 3
15
—
(silent
arm/disarm)
Add a New
Remote to
Channel 4
16
—
(optional
remote
accessory)
Example
To change the AutoArming feature from its factory setting of "on" to "off,"
you would do the following:
Turn the ignition key to the ON position.
Enter your valet code, then immediately tap and release the
momentary side of the PlainView switch 4 times (you will hear a
single chirp upon the 4th press).
Wait 3 seconds. The system will sound one more chirp to confirm that
the AutoArming setting has been changed.
Turn the ignition off (you'll hear 3 chirps to confirm exit of program
mode).
That's all there is to it!
Secondary
completion
action
confirmation
—
seconds after
Press remote control button 1
Press remote control button 2
Press remote control button 3
Press remote control button 4
of the optional
4-button/12-channel
remote control
12
Program
Result
1 chirp 3
Change state from
OFF to ON or vice-versa
last tap
Button 1/channel 1 code
2 chirps
of the new remote control
has been memorized
Button 2/channel 2 code
2 chirps
of the new remote control
has been memorized
Button 3/channel 3 code of
2 chirps
the new remote control
has been memorized
Button 4/channel 4 code
2 chirps
of the new remote control
has been memorized
Advertisement
Table of Contents
