Panasonic KX-TGB310C Operating Instructions Manual page 31

Problem
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts in
and out.
The handset does not ring.
I cannot make a call.
I cannot make long distance
calls.
Caller ID
Problem
Caller information is not
displayed.
For assistance, visit www.panasonic.ca/english/support
Cause/solution
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 8).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 23).
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
R The ringer volume is turned off. Adjust the ringer volume
(page 12, 19).
R Night mode is turned on. Turn it off (page 21).
R The dialing mode may be set incorrectly. Change the
setting (page 11).
R Make sure that you have long distance service.
Cause/solution
R You must subscribe to Caller ID service. Contact your
phone service provider for details.
R If your unit is connected to any additional telephone
equipment such as a Caller ID box or cordless telephone
line jack, plug the unit directly into the wall jack.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
R The name display service may not be available in some
areas. Contact your phone service provider for details.
R Other telephone equipment may be interfering with this
unit. Disconnect the other equipment and try again.
Useful Information
, ) and the charge contacts
31