Advertisement
Page 2 of 36
FOREWORD
The compressed air dryer systems have been designed and manufactured to ensure that
maximum safety and performance is achieved. It is expected that users of these systems
will employ safe working practices and ensure that when installing, commissioning,
operating or maintaining the equipment, any legal requirements are fulfilled. For example,
in the UK, users should refer to the Health and Safety Act, 1974.
All ancillary equipment such as pipework, valves, fittings etc., must be suitable for the
pressures and capacities involved.
Replacement parts are available from your distributor or the manufacturers ( see front page
for information). The adoption of a regular servicing policy is strongly recommended and
will result in ensuring that a high performance is achieved. Serial numbers and customer
order numbers should be referred to in any communication. (Serial numbers can be found
on the identification plate on the left hand side of the instrumentation shroud). The figure
number and the appropriate diagram in this manual and the item number (shown in circle,)
will also assist in part identification.
Any warranty will be invalidated if the dryer is not commissioned in accordance with the
manufacturers recomendations or non-approved parts substituted. Substitute parts could
reduce the performance or service life in addition to creating potential hazards.
The manufacturers reserve the right to modify the contents of this manual without notice.
The data given is a guideline to users and in no way binding on the manufacturers.
BEFORE SERVICING OR DISMANTLING ALL PRESSURE MUST BE RELEASED FROM
THE SYSTEM AND ITS ASSOCIATED PIPEWORK AND ANY ELECTRICAL SUPPLY
ISOLATED.
Advertisement
