SMA SUNNY ISLAND 4.4M Operating Manual page 152

14 Troubleshooting
Event number Message, cause and corrective measures
7102 Parameter file not found or defective
Parameter file not found / defective. The parameter file could not be found or is defective.
The update failed.
Corrective measures:
27103
Set parameter
The parameter change has been adopted.
27104
Parameters set successfully
The parameter changes were successfully adopted.
7105 Parameter setting failed
Parameters could not be set using the memory card.
Corrective measures:
7106
Update file defective
The update file is defective. The update failed.
Corrective measures:
27107 Update file OK
The update file is suitable for this inverter and its components and is fully available for the
next update step.
27108 SD memory card is read
The inverter is currently reading the SD memory card.
27109 No new update SD memory card
The micro SD memory card contains an update file that has already been used.
7110
No update file found
7112
Update file successfully copied
Update file was copied successfully to the inverter's internal memory.
7113 The memory card is full or write-protected
27301 Update communication
The inverter is updating the communication component.
27302 Update main CPU
The inverter is updating the inverter component.
152 SI44M-80H-13-BE-en-15
• Copy the parameter file to the correct folder again.
• Make sure thresholds of the parameters are complied with.
• Change the parameter again.
• For grid-relevant parameter: Ensure that the SMA Grid Guard code is available.
• Update the firmware again.
SMA Solar Technology AG
Operating manual