Starting The Program - Beko DRYS723W User Manual

If the water tank fills up while the program
continues, the warning symbol starts flashing
and the machine goes into stand-by. In this
case, empty the water tank and start the
program by pressing the Start / Stand-by
button. Warning symbol turns off and program
resumes.
Cleaning the filter drawer
Warning symbol flashes periodically to remind
that filter drawer must be cleaned.
C
NOTE
• For detailed information, See 6
Maintenance and cleaning.
Loading cover is open
If loading cover of the dryer is open while
drying, Stand-by symbol turns on and program
progress symbol flashes.
End time
You can delay the end time of the program up
to 24 hours with end time function.
• Open the loading door and place the
laundry.
• Select drying program, spin cycle and if
needed, additional functions.
Dryer / User Manual
• Press the End Time selection button and
set the delay time you wish. End Time
symbol turns on. (When pressed and hold
the button, End Time proceeds non-stop).
• Press the Start / Stand-by button. End
time countdown starts and Start symbol
turns on. ":" Separator in the middle of
displayed delay time flashes.
C
You can add or remove laundry
within end time. End Time
symbol will turn off at the end
of countdown, drying starts and
duration of program is displayed.
Displayed time is the sum of
normal drying time and end time.
Changing the end time
If you want to change the duration during the
countdown:
• Press the On/Off/Cancel button for 3
seconds to cancel the program. Turn on
the machine again and repeat the Delay
Setting process for the duration you wish.
• When your machine is turned on for the
first time, it turns on with the declaration
program (cotton wardrobe dry).
Cancelling the end time function
If you want to cancel the end time countdown
and start the program immediately:
• Press the On/Off/Cancel button for 3
seconds to cancel the program.
• Press the On/Off/Cancel button to start
you previously selected program.

5.8 Starting the program

Press the Start/Stand-by button to start the
program.
Indicating start of the program, Start symbol
turns on, ":" separator in the middle of
remaining time keeps flashing. Program
Progress Symbol turns on.
43