Step 5: Install The Mounting Plate - LG LMV1630 Installation Instructions Manual

STEP 5: Install The Mounting Plate

The Oven Must Be Connected To At Least One
Wall Stud.
1. Draw a vertical line on the wall at the center of the 30" wide
space. Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making sure that
the tabs are against the bottom of the cabinet. Line up the
notch and center line on the mounting plate to the center line
on the wall.
2. While holding the mounting plate with one hand, draw circles
on the wall at holes A, B, C, and D. Four holes must be used
for mounting. If the holes are not used, the installation will not
be secure. Installer must use these holes for proper
installation. Use toggle bolts through these holes unless one
of them lines up with a stud. Use a wood screw for studs.
NOTE: Draw a fifth circle inside area E, through one of the
bottom holes to match the location of a stud. For wall-
vented: The oven requires a rear wall cutout opening for
the rear wall duct and the exhaust adaptor must be
attached to the mounting plate. See the next page on
how to prepare the rear wall cutout opening and the
exhaust adaptor/mounting plate for wall-vented.
3. Drill holes on the circles. If there is a stud, drill a 3/16 hole for
lag screws. If there is no stud, drill a 5/8 hole for toggle bolts.
Make sure to use at least 1 lag screw in a stud, and 4 toggle
bolts in the drywall or the plaster.
4. Attach the plate to the wall. To use spring toggle head bolts:
Remove the toggle wings from the bolts. Insert the bolts into
the mounting plate and replace the spring toggle head to 3/4
past the bolt ends. Insert the spring toggle head into the
holes in the wall to mount the plate. You may pull forward on
the plate to help in tightening the toggle bolts. Tighten all
bolts.
Mounting
Plate
Space More Than Wall Thickness
Toggle Wings
Toggle Bolt
Wall
Figure 28
Minimum 66
From the Floor
A
C
Support Tab
Minimum 66
From the Floor
A
Bolt
End
Support Tab
– 15 –
3/16 Hole on Studs
5/8 Hole on Drywall Only
"
For Wall-
Vented Only
Draw Lines
on Studs
Mounting
Plate
Draw
Center Line
Center Line
E
Support Tab
(1-piece Mounting Plate)
3/16 Hole on Studs
5/8 Hole on Drywall Only
"
For Wall-
Vented Only
Draw Lines
on Studs
Draw
Center Line
Mounting
Plate
C Center Line
E
(3-piece Mounting Plate)
Figure 27
B
D
B
D
Support Tab