Step 5: Install The Mounting Plate - LG LMV1683ST Installation Instructions Manual

STEP 5: Install The Mounting Plate

The Oven Must Be Connected To At Least One
Wall Stud.
1. Center rear wall template in operating by lining up the
plumb line on wall with centerline on template.Then securely
tape or tack the rear wall template in place.Make sure the
minimum width is 30 inches and that the top of the rear
wall template is located a minimum of 30 inches above
the cooking surface. See Figure 24.
NOTE: If the cabinets are not plumb, adjust the rear wall
template to the cabinets. If the front edge of the
cabinet is lower than the back edge, adjust the
template to be level with the cabinet front.
2. Drill holes at points A, B and C. Drill the fourth hole
inside area D, through one of the bottom holes to match the
location of a stud. If there is a stud, drill a 3/16 hole for lag screws.
If there is no stud, drill a 5/8 hole for toggle bolts.
These holes must be used for mounting. If the holes are not used,
the installation will not be secure. Installer must use these holes
for proper installation.
Use toggle bolts through these holes, unless one of them
lines up with a stud. Use a wood screw for studs.
Make sure to use at least 1 lag screw in a stud,
and 3 toggle bolts in the drywall or the plaster.
NOTE: Cut out the shaded area marked F on the REAR
WALL TEMPLATE for wall-vented.
3. Remove the template from the rear wall.
4. Attach the plate to the wall. To use spring toggle head bolts:
Remove the toggle wings from the bolts. Insert the bolts into
the mounting plate and replace the spring toggle head to 3/4
past the bolt ends. Insert the spring toggle head into the
holes in the wall to mount the plate. You may pull forward on
the plate to help in tightening the toggle bolts. Tighten all
bolts.
From the Floor
Mounting
Plate
– 15 –
3/16 Hole on Studs
5/8 Hole on Drywall Only
"
Minimum 66
Draw Lines
on Studs
Center Line
Mounting
Plate
Center Line
A
C
D
Support Tab
Figure 28
Space More Than Wall Thickness
Toggle Wings1
Toggle Bolt
Wall
Figure 29
For Wall-
Vented Only
Draw
B
Support Tab
Bolt
End