Table of Contents
Advertisement
Insert the power supply into the power supply bay until it clicks into place.
3.
Connect the power cord to the power supply.
4.
Route the power cord. Use best practices when routing power cords and other cables. A cable
5.
management arm is available to help with routing. To obtain a cable management arm, contact an HP
authorized reseller.
Connect the power cord to the AC power source.
6.
Be sure that the power supply LED is green
7.
FlexLOM option
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Power down the server (on page 21).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
To reduce the risk of personal injury, electric shock, or damage to the equipment,
("Rear panel LEDs and
buttons" on page 12).
Hardware options installation 61
Advertisement
Table of Contents
