Table of Contents
Advertisement
4
Chapter 2
Figure 1 Removing the cover screws
4. Place your thumbs on the top surface above where the end screws were removed.
Figure 2 Unlatching the cover
5. (a) Grasp the overhanging cover edge and raise the edge
With a continuous motion, push firmly downward and towards the back panel (pushing
down unlatches the hooks under the cover). The cover will shift approximate 1/4 inch to
hang over the back panel, as shown in Figure 2.
about 1-1/2 inches, and then (b) pull the cover out towards the back panel at the same
angle to free the opposite end of the cover from the remaining hooks, as shown in
Figure 3.
Advertisement
Table of Contents
