Zanussi ZDLN1510 User Manual page 30

Water softener level
8
9
10
In case of the high water softener setting, it may
occur also in the middle of the programme, before
the rinse (twice during a programme). Regeneration
initiation has no impact on the cycle duration,
unless it occurs in the middle of a programme or at
the end of a programme with a short drying phase.
In such cases, the regeneration prolongs the total
duration of a programme by additional 5 minutes.
Subsequently, the rinsing of the water softener that
lasts 5 minutes may begin in the same cycle or at
the beginning of the next programme. This activity
increases the total water consumption of a
programme by additional 4 litres and the total
energy consumption of a programme by additional
2 Wh. The rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible more than
one in the same cycle) may prolong the programme
duration by another 5 minutes when it occurs at any
point at the beginning or in the middle of a
programme.
All the consumption values mentioned
in this section are determined in line
with the currently applicable standard
in laboratory conditions with water
hardness 2.5mmol/L (water softener:
level 3) according to the regulation:
2019/2022 .
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
How to set the water softener level
Make sure the appliance is in user mode.
1. Wait until the indicator
indicator
remaining indicators are off.
The intermittent flashing of the indicator
the current setting: e.g. 5 flashes + pause + 5
flashes = level 5.
2. Press the programme button repeatedly to
change the setting. Each pressing of the
programme button increases the level number.
After reaching the level 10, the count starts
again from the level 1.
30
Amount of water (l)
5
3
3
starts to flash, the
continues to flash and the
3. Press the on/off button to confirm the setting.
THE RINSE AID EMPTY NOTIFICATION
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically released
during the hot rinse phase.
When the rinse aid chamber is empty, the rinse aid
indicator is turned on notifying to refill rinse aid. If
the drying results are satisfactory while using multi-
tablets only, it is possible to deactivate the
notification for refilling rinse aid. However, for best
drying performance, always use rinse aid.
If standard detergent or multi-tablets without rinse
aid are used, activate the notification to keep the
rinse aid refill indicator active.
How to deactivate the rinse aid empty
notification
Make sure the appliance is in user mode.
1. Press the programme button immediately.
The indicator
2. Wait until the indicator
and the remaining programme indicators are
off.
The indicator
•
on.
•
off.
3. Press the programme button to change the
setting.
4. Press the on/off button to confirm the setting.
ACOUSTIC SIGNALS
Acoustic signals sound when a malfunction of the
appliance occurs. It is not possible to deactivate
these acoustic signals.
There is also an acoustic signal that sounds when
the programme is completed. By default this
acoustic signal is deactivated but it is possible to
activate it.
How to activate the acoustic signal for the
end of the programme
Make sure the appliance is in user mode.
1. Press the programme button twice.
shows
The indicator
2. Wait until the indicator
and the remaining programme indicators are
off.
The indicator
starts to flash.
continues to flash
shows the current setting:
is on = Rinse aid empty notification is
is off = Rinse aid empty notification is
starts to flash.
continues to flash
shows the current setting: