Filament Circuit Faults - Siemens MOBILETT Plus Manual

13 - 4

Filament circuit faults

When a fault occurs in the filament circuit, the following actions are initiated:
The buzz on board D3
•
generates 10 beep tones,
•
the green "ready" LED on board D3 is turned off,
•
the Control and display panel is switched off,
•
the filament current is switched off,
•
an error message is shown in the Control and display panel.
The error message can be acknowledged by pressing the "kV+" selection button.
If this fails to switch off the error message, proceed according to the Service Instructions!
MOBILETT Plus/ Plus E Register 6 SPR8-215.850.02
Rev. 01
Page 4 of 4
01.02 SPS-UD
Filament circuit
Siemens-Elema AB
Solna, Sweden
13