Windows Printing Via Tcp/Ip - Kyocera KM-1530 Quick Configuration Manual

The following sections cover TCP/IP configuration for Windows 95/98/Me, NT 4.0 and 2000. The IB-2x
provides support for several methods of TCP/IP printing, including the Internet Printing Protocol (IPP)
and E-mail printing (for the IB-21E/22 only), both of which enable printing over the Internet.
Verify that TCP/IP is Installed
Check under ,
prior to configuring TCP/IP printing.
Configure the IB-2x IP Address
See the IP Address Configuration section later in this guide.
Configure the Port and Install the Printer Driver
1. Insert the CD-ROM (Kyocera Mita Network Library or Kyocera Mita Software Library), select
and run the KPrint Add Port wizard. The wizard will guide you through the port
configuration. For information on the Print via E-mail option in KPrint, see the section on the
following page on e-mail printing.
2. Run the Windows Add Printer wizard (
2.1. When the wizard asks, "How is this printer attached to your computer?", select
2.2. On the list of available ports, select the IPP or LPR port which was created by the KPrint Add
Port wizard.
3. Follow the prompts to complete the Add Printer wizard.
4. Use the following procedure to set the printer for sharing.
4.1. Go to ,
button and click the appropriate checkbox to allow printer sharing.
4.2. Under ,
wizard, select
TCP/IP Required Components
The following steps describe how to check for and, if necessary, add the Windows TCP/IP components
which are necessary for LPR Printing.
1. Check under
the list of Network Protocols, click on
2. Select the
list of Network Services, click on
3. Click on when all protocols and services have been added. If the TCP/IP protocol has just
been added, Windows will prompt for the IP address and other TCP/IP parameters. The new
protocols and services will not be available until the system is restarted.
Configure the IB-2x IP Address
See the IP Address Configuration section later in this guide.
, ,
,
is installed. On the same screen, click the
, right click on the printer just created with the Add Printer
, click on
, ,
to install it.
tab. If either Microsoft TCP/IP Printing or Simple TCP/IP Services is not in the
to install them.
. If TCP/IP is not on the list, it must be installed
, , ,
, and verify that
and enter the desired
, ,
8
).
.
. If TCP/IP Protocol is not in
.