Advertisement
Necessary procedure after battery change
When the battery is replaced with a new one, the information stored in the built-in IC does not
correspond with the time actually displayed. Before using the watch, therefore, be sure to reset the
circuit following the procedure below.
* In case any of the hands should move improperly, follow the procedure below to adjust the hand movement.
** The hands move quickly if the
respective buttons are kept
pressed.
14
CROWN
A
A
and
B
A
B
CROWN
Pull out to second click.
Press and hold at the same time for 2
B
seconds.
* STOPWATCH second hand turns half a
revolution counterclockwise and then returns
to where it was, while STOPWATCH 1/10
second hand turns a full revolution clockwise
and stops.
Press repeatedly to reset STOPWATCH
1/10 second hand to "0" position. **
Press repeatedly to reset STOPWATCH
second and minute hands to "0" posi-
tion. **
Turn to set the time, and then push
back in to normal position.
Advertisement
