[Standby Mode]; [High Altitude] - NEC PE506WL User Manual

Setting
On start
Standby mode
High altitude
Cooling fast
Key lock
Contrast optimization
Baud rate
Laser control
Sound
HDMI setup
Note:
• After the power is turned off, please wait about 20s after unplugging the AC, and then you can turn on the power. If the power is turned
on immediately, it may not work properly.

[Standby mode]

Select this function to switch different standby mode.
1) Press ▲ ▼ button to select [Standby mode] menu.
2) Press the ENTER button.
3) Press ▲ ▼ button to adjust levels.
Normal...... Although the power consumption on this mode is lower than on the [Network standby] or [Sleep] mode,
when this mode is selected, only the POWER button on the top control panel or the remote control will work..
Network standby...... Although the power consumption on this mode is higher than on the [Normal] mode, this mode
allows you to turn on the projector from standby condition by using the Wake on LAN feature
(hereafter referred to as WoL) via LAN.
Consult your network administrator for more information about WoL.
Sleep ........ Although the power consumption on this mode is higher than on the [Network standby] mode, this mode
spends less time to turn on the projector from standby condition via LAN compared to the [Network
standby] mode.
To control the projector by using our application software NaViSet Administrator 2, select the [Sleep]
mode.
Setting
On start
Standby mode
High altitude
Cooling fast
Key lock
Contrast optimization
Baud rate
Laser control
Sound
HDMI setup

[High altitude]

You can change the setting about speed of cooling fan according to the altitude your projector is operating at.
1) Press ▲ ▼ button to select [High altitude] menu.
Off
Normal
Off
60 Sec
Off
Off
9600
Off
Normal
Off
60 Sec
Off
Off
9600
42
5. Using On-Screen Menu