Table of Contents
Advertisement
POWER SAVE
SET – UP
Once you enable this function, the monitor is
temporarily switched off to reduce power
consumption ( Sleep mode ) if the camera is not
used for about 30 seconds. If the camera is then
left unused for a further time ( 2 minutes or 5
minutes ) , it is automatically switched off. Use
this function when you want to get the maximum
possible running time from the battery.
G
!
Power Save is disabled when the camera is connected
to a USB port.
N
To restore power to the camera
The Sleep function does not operate when the LCD monitor is switched off or when
the camera is in Setup or Playback mode. However, if the camera controls are not
used for some time ( 2 minutes or 5 minutes ) , the camera automatically switches off.
If the camera has been automatically switched off, switch it back on by moving the
Power switch to the OFF position 1 briefly and then back to ON 2.
84
When the camera is in sleep mode, pressing the
shutter button down halfway brings the camera
back to full operational mode. This is a useful
feature as it allows you to take pictures more
quickly than switching the camera off and then
on again. You can also take a picture by
pressing the shutter button all the way down.
G
!
Operation can also be restored by pressing buttons
other than the shutter button.
N
FORMAT
SET – UP
Formatting erases protected files also.
Formatting erases all files, including protected files.
Initialize the xD - Picture Card for use in the
camera.
G
!
You should copy important files that you do not want
to be erased to your computer or another xD - Picture
Card.
1 Use "d" or "c" to select "YES".
2 Pressing the "MENU/OK" button erases all
the files and initializes the xD - Picture Card.
G
!
∂
ƒ
å
If the "
" "
" "
˙
or "
" message appears, refer to
P.119 before formatting the media and take the
appropriate measures.
4
"
85
Advertisement
Table of Contents
