Table of Contents
Advertisement
Available languages
Available languages
Maintenance
After each use of the trimmer, complete the following:
1.
Remove the battery pack from the trimmer.
2.
Wipe the trimmer clean with a damp cloth. Do
not hose the trimmer down or submerge it in
water.
CAUTION
The line cutoff blade on the deflector is
sharp and can cut you.
Do not use your hands to clean the
deflector shield and blade.
3.
Wipe or scrape clean the cutting head area any
time there is an accumulation of debris.
4.
Inspect the machine, check and tighten all
fasteners. If any part is damaged or lost, repair
or replace it.
5.
Brush debris away from air intake vents and
exhaust on motor housing to prevent the motor
from overheating.
Replacing the Line
Use only 2.4 mm (0.095 inch) diameter monofilament
line.
1.
Remove the battery pack.
2.
Remove any existing line on the spool by
repetitively pressing the bump head while pulling
the line out equally from both sides of the bump
head.
3.
Using 2.4 mm (0.095 inch) line, cut a piece of
line that is no longer than 7.3 m (24 ft).
Important:
Do not overload the spool.
Important:
Do not use any other gauge
or type of line, as this could damage the
trimmer.
4.
Press and turn the bottom of the trimmer head
in the direction shown by the arrows (clockwise)
on the bottom of the bump head until the bottom
green marks align with the green marks beneath
the eyelets
(Figure
5.
Insert 1 end of the line straight into the eyelet
and push the line through until it comes out
through the eyelet on the other side.
14).
1. Eyelet
2. Line
Important:
Do not disassemble the trimmer
head.
6.
Pull the line through the eyelets until there is an
equal length of line on each side of the trimmer
head.
7.
Hold the string trimmer in place with one hand.
With your other hand, turn the bottom of the
trimmer head in the direction shown by the
arrows (clockwise) on the bottom of the bump
head to wind the line; leave about 152 mm (6
inches) extending beyond the eyelet on each
side.
14
Figure 14
3. Eyelet alignment mark
4. Bottom alignment mark
g367291
Advertisement
Table of Contents
