Table of Contents
Advertisement
Open the control panel and remove the water
‒
tank.
Thoroughly rinse the water tank and fill it with
‒
fresh water.
Slide in the water tank and close the control
‒
panel.
Use
to start rinsing.
‒
a A signal sounds when each rinse cycle has ended.
20 Drying
To prevent residual moisture, dry the cooking compart-
ment following operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
Do not use the appliance if there is water on the
▶
cooking compartment floor.
Wipe away any water on the cooking compartment
▶
floor before operation.
20.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the "Drying" function.
Allow the appliance to cool down.
1.
Remove dirt from the cooking compartment.
2.
Wipe away the water in the cooking compartment.
3.
Dry the cooking compartment.
4.
Leave the cooking compartment to dry with the
‒
appliance door open for 1 hour.
21 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
21.1 Detaching the rails
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
1.
Lift the rail forwards slightly
Pull the whole rail to the front
2.
and detach it
.
and remove it.
Once the second rinsing cycle is complete:
6.
Empty and dry the water tank.
‒
→ "Emptying the water tank", Page 17
Press
to switch the appliance off.
‒
a Descaling is complete and the appliance is ready
for use.
To use the "Drying" function, set "Drying".
‒
→ "Setting the drying process", Page 27
Setting the drying process
Requirement: → "Drying the cooking compartment",
Page 27
Press
.
1.
Press "Cleaning".
2.
Press "Drying".
3.
a The duration appears in the display. The duration
cannot be changed.
Press
to start.
4.
a The drying process starts and the duration counts
down.
a Once the drying process has ended, an audible sig-
nal sounds and the display shows the cooking time
as zero.
Press
to switch the appliance off.
5.
To dry the cooking compartment completely, leave
6.
the appliance door open for 1 to 2 minutes.
Clean the rail.
3.
→ "Cleaning products", Page 23
21.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
First, push the rail into the middle of the rear
1.
socket
until the rail rests against the cooking
compartment wall, and then push this back
Drying en
.
27
Advertisement
Table of Contents
