Dell PowerEdge C8220X Installation Manual page 15

C8220X_MIC5110P7120P_IG.book Page 15 Monday, August 12, 2013 5:42 PM
16
Align the left air baffle with the screw holes on the back of the sled cover.
17
Secure the left air baffle to the sled cover using the two M3 screws. Tighten the screws to
5.21 in-lb.
18
Route the power cables along the inside wall of the sled cover.
19
Secure the cables to the retaining clips.
Figure 1-18. Installing the Left Air Baffle
1 left air baffle
3 power cables
20
Replace the top cover.
NOTE:
Be careful not to damage the twin axial cable on the back GPGPU card riser
when replacing the top cover.
21
Close the sled.
22
Replace the sled in the server enclosure.
2
1
2 M3 screws (2)
4 retaining clips (3)
Installation Guide
3
4
15