Packet Data Settings - Nokia N86 User Manual

WLAN network mode
●
create an ad hoc network, and to allow devices
to send and receive data directly; a WLAN access
point device is not needed. In an ad hoc network,
all devices must use the same WLAN network
name.
WLAN security mode
●
used: WEP, 802.1x
WPA/WPA2. If you select
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network
supports them.
Use access point
●
to set the device to ask for confirmation before
the connection using this access point is created
or Automatically
the destination using this access point
automatically.
To enter the settings for the selected security mode,
select WLAN security
Advanced WLAN settings
Select Options
>
following:
IPv4 settings
●
device, the subnet IP address, the default
gateway, and the IP addresses of the primary and
secondary DNS servers. Contact your internet
166 service provider for these addresses.
IPv6 settings
●
— Select Ad-hoc
— Select the encryption
(not for ad hoc networks), or
Open network, no
— Select After confirmation
to set the device to connect to
settings.
Advanced settings and from the
— Enter the IP address of your
— Define the type of DNS address.
to Ad-hoc channel
●
enter a channel number (1-11) manually, select
User defined.
Proxy server address
●
the proxy server.
Proxy port number
●
number.

Packet data settings

Select Menu
>
Connection
>
The packet data settings affect all access points
using a packet data connection.
Packet data connection
●
available and you are in a network that supports
packet data, the device registers to the packet
data network. Starting an active packet data
connection (for example, to send and receive e-
mail) is quicker. If there is no packet data
coverage, the device periodically tries to
establish a packet data connection. If you select
When needed, the device uses a packet data
connection only if you start an application or
action that needs it.
Access point
●
to use your device as a packet data modem to a
compatible computer.
(only for ad hoc networks) — To
— Enter the address for
— Enter the proxy port
Tools Settings and
>
Packet data.
— If you select
— The access point name is needed
When