Kenwood KDC-X305 Instruction Manual page 53

Installing the unit (without mounting sleeve)
1
Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle
mounting bracket and secure the unit with screws (supplied/
commercially available).
Removing the unit
Part list (supplied)
(A) Faceplate (×1)
(B) Trim plate (×1)
(C) Mounting sleeve (×1)
(D) Wiring harness (×1)
(E) Extraction key (×2)
Use only the specified screws.
Using wrong screws might damage
the unit.
(F) Screws (supplied for
M5 × 7 mm (×4)
M5 × 6 mm (×4)
M4 × 8 mm (×1)
Wiring connection
Fuse (10 A)
a Brown: Connect to the device
equipped with muting feature
to mute this unit
b Blue/white: To the power
control terminal when using
the optional power amplifier
or to the antenna control
terminal in the vehicle
)
c Light blue/yellow: To the
steering wheel remote control
adapter
d Red: Ignition 12 V
e Yellow: Battery 12 V
f Black: Ground
Antenna terminal
If no connections are made, do not
let the wire come out from the tab.
Car fuse box
Ignition switch
Car fuse box
Battery
g White ª, White/black ·:
Front speaker (left)
h Gray ª, Gray/black ·:
Front speaker (right)
i Green ª, Green/black ·:
Rear speaker (left)
j Purple ª, Purple/black ·:
Rear speaker (right)
3