Magnavox MDR867H Owner's Manual page 45

■
For Wireless Connection
1
Press [ HOME ], then Select "Settings"
"General Settings"
[ OK ].
2
Select "Network Connection", then press
[ OK ].
• Connecting method screen will appear.
3
Select "Wireless" using [ K/ L ], then press
[ OK ].
• You will be asked to Select "Auto Scan" or "Manual",
or "Easy Connect". Select an adequate method
according to your Wireless Networks and settings.
Auto Scan Auto Scan
This method lets you Select an SSID* from the SSID List
automatically obtained by performing "Auto Scan".
* SSID (Service Set IDentifier) is a wireless Network name
which is used to identify your Wireless Networks (access
Point) on the Network.
4
Select "Auto Scan" using [ K/ L ], then press
[ OK ].
• Access Points List will be Displayed.
appears next to the SSID (access Point) that is
protected with security.
5
Select an access Point to which you wish to
connect this unit using [ K/ L ], then press
[ OK ].
6
Enter the Security Key using the Software
Keyboard. press [ OK ].
• For details on how to use the Software Keyboard,
refer to 'Guide to the Software Keyboard' on page
42
7
Select "Next", then press [ OK ].
"Network", then press
8
Select "Auto" using [ K/ L/ 0 / 1 ], then
press [ OK ].
• Connection test will Start and the test result will be
Displayed.
9
Press [ OK ] to complete the Network
setup.
Manual Manual
Select this if you wish to configure the wireless Network
settings manually by entering an SSID and the Security Key.
4
Select "Manual" using [ K/ L ], then press
[ OK ].
• SSID entry screen will appear.
5
Enter an SSID using the Software Keyboard.
• For details on how to use the Software Keyboard,
refer to 'Guide to the Software Keyboard' on page
42.
6
Press [ OK ].
• Security method selection screen will appear.
7
Select an adequate security mode using
[ K/ L ], then press [ OK ].
• Security Key entry screen will appear.
• If you Select "None" for a security mode, Connection
test will Start and the test result will be Displayed.
8
Enter the Security Key using the Software
Keyboard. Press [ OK ].
• For details on how to use the Software Keyboard,
refer to 'Guide to the Software Keyboard' on page
42.
9
Select "Next", then press [ OK ].
10
Select "Auto" using [ K/ L ], then press
[ OK ].
• Connection test will Start and the test result will be
Displayed.
11
Press [ OK ] to complete the Network
setup.
EN
EN - 45