Monogram ZWL1126SR Installation Instructions Manual page 8

Flush Mount Installation Instructions
2. Install deflector as shown in Figures 10 and 11
Shelf detail showing the deflector vent during
installation. Position deflector vent and mark holes.
Pre drill using a 1/16" bit before mounting.
Figure 10
Shelf detail showing the deflector vent installed.
Figure 11
3. Place the drawer adjacent to the wall or cabinet.
Plug the power supply cord into the electrical outlet.
4. Loop (do not tie) a 36" (91 cm) string around the
power supply cord before the drawer is slid into
place. This will keep the cord from falling behind
the drawer.
5. Lift drawer into cabinet cutout using the opening as
a grip. Carefully guide the drawer into the prepared
opening.
6. As you slide the drawer back, pull the string so that
the cord will lie on top of the drawer in a natural
loop and avoid pinching the cord between the
drawer and the wall.
8
7. When you are sure the cord is out of the way, slide
the drawer ¾ way back into the opening. Remove
the string by pulling on one end of the loop.
8. Slide the drawer all the way back until the mounting
flanges touch the cleats in the cabinet opening.
9. Open the drawer. Using the 4 holes on the
mounting flanges as a template, drill pilot holes the
cabinet using a 1/16" drill bit. See Figure 12.
10. Secure the drawer with the 4 screws supplied.
Figure 12
It is recommended that the screws be hand
tightened.
Mounting
Flange
31-7000165 Rev. 1