Clearances And Dimensions - Monogram ZWL1126SR Installation Instructions Manual

CLEARANCES AND DIMENSIONS

• Dimensions that are shown in Figure 1 must be
used for Standard Installation. Given dimensions
provide minimum clearance. Locate electrical outlet
in the shaded area in the upper left-hand corner of
the cutout. See Figure 4.
• Contact surface must be solid and level. Pay
special attention to the floor on which the Drawer
Microwave will sit. The floor of the opening should
be constructed of plywood strong enough to support
the weight of the oven (about 100 pounds).
• Check location where the Drawer Microwave will be
installed for proper electrical supply.
• Your oven can be built into a cabinet or wall by itself
or under a gas, under an electric wall oven, or under
selected cook top models.
• Be sure that the clearance of the floor between the
wall oven and the drawer microwave is a minimum
of 2-inches.
• The microwave interior will easily accommodate a 9"
x 13" oblong dish or a bag of microwave popcorn.
• The oven can also be mounted flush. Please see
instructions for flush mounting included with the
Flush Mount Deflector vent.
24" DRAWER MICROWAVE
MEASUREMENTS
• Figures 1 and 2 contain many drawer microwave
measurements for reference when planning the
drawer location.
• This drawer microwave can be installed below any
electric or gas wall oven or under selected cook
top models.
• Can also be installed using an electrical outlet in an
adjacent cabinet within the areas where the provided
electrical cord can reach. Power cord access hole in
cabinet should be a minimum of 1 1/2" diameter hole
and deburred of all sharp edges.
IMPORTANT
• Always allow sufficient power cord length to the
electrical outlet to prevent tension.
• Always check electrical codes for requirements.
31-7000165 Rev.1
Design Information
24" DRAWER MICROWAVE
MEASUREMENTS (cont)
Figure 1
countertop
Figure 2
Preferred electrical
outlet location*
4"
22 1/8"
7/8"
overlap
231/2"
min
36"
height
24"
cabinet min.
15 15/16"
23 7/8"
6"
Anti-Tip
5"
14 13/16" to
bottom of
11/16"
anti-tip
overlap
14 13/16"
7/8"
overlap
1/16"
overlap
support
100 lbs
18 1/2" to
top of floor
21 5/8"
1419/32"
15" auto
drawer
opening
21 5/8"
1 11/16" door
thickness
Block
31/2"
block
Floor
must
3