Wireless Mini-Card(S); Removing The Mini-Card(S) - Dell XPS L502X Service Manual
Hide thumbs
Also See for XPS L502X:
- Setup manual (112 pages) ,
- Service manual (110 pages) ,
- Service manual (56 pages)
Table of Contents
Advertisement
Back to Contents Page
Wireless Mini-Card(s)
Dell™ XPS™ L502X Service Manual
Removing the Mini-Card(s)
Replacing the Mini-Card(s)
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
computer.
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer has one full Mini-Card slot and one half Mini-Card slot:
One full Mini-Card slot — supports a Wireless Wide Area Network (WWAN) or TV tuner module.
l
One half Mini-Card slot — supports a Wireless Local Area Network (WLAN) and bluetooth combo card or Worldwide Interoperability for Microwave
l
Access (WiMax) card.
NOTE:
Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed.
Removing the Mini-Card(s)
1. Follow the instructions in
2. Remove the battery (see
3. Remove the module cover (see
4. Disconnect the antenna cables from the Mini-Card(s).
5. Remove the screw that secures the Mini-Card to the system board.
NOTE:
Your computer can only support either a WWAN Mini-Card or a TV tuner module in the full Mini-Card slot at a time.
1 antenna cables (2) 2 Mini-Card
3 screw
6. Lift the Mini-Card(s) out of the system-board connector.
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
To help prevent damage to the system board, remove the main battery (see
Before You
Begin.
Removing the
Battery).
Removing the Module
4 system-board connector
UserManuals.info
Removing the
Cover).
Battery) before working inside the
Advertisement
Table of Contents
