Dell XPS L502X Service Manual page 17

1 camera cable
3 digitizer board cable
6. Remove the ten screws that secure the display panel to the display back cover.
7. Remove the two screws that secure the digitizer board to the display back cover.
8. Note the routing of the antenna cables and remove them from the routing guide on the right display hinge.
9. Note the routing of the display cable and remove it from the routing guide on the left display hinge.
1 display panel
3 display cable
5 antenna cables
10. Lift the display panel off the display back cover.
Replacing the Display Panel
1. Follow the instructions in
2. Place the display panel over the display back cover.
3. Route the display cable through the routing guide on the left display hinge.
4. Route the antenna cables through the routing guide on the right display hinge.
5. Replace the ten screws that secure the display panel to the display back cover.
6. Replace the two screws that secure the digitizer board to the display back cover.
7. Connect the camera cable to the connector on the camera module.
8. Connect the digitizer board cable to the connector on the digitizer board.
9. Replace the display bezel (see
10. Replace the display assembly (see
CAUTION:
result in damage to the computer.
Great user manuals database on
2 display panel
2 screws (12)
4 digitizer board
Before You Begin.
Replacing the Display
Replacing the Display
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
UserManuals.info
Bezel).
Assembly).