3
system board connector
Replacing the VGA Connector Board
1. Follow the instructions in
Before You
2. Place the VGA connector board along with the cable on the computer base and press the VGA connector board until it is seated fully.
3. Route the VGA connector board cable into the routing guide and connect the cable to the connector on the system board.
4. Replace the middle cover (see
5. Replace the display assembly (see
6. Replace the palm rest (see
7. Replace the keyboard (see
8. Replace the optical drive (see
9. Replace memory module(s) (see
10. Replace the base cover (see
11. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Begin.
Replacing the Middle
Cover).
Replacing the Display
Assembly).
Replacing the Palm
Rest).
Replacing the
Keyboard).
Replacing the Optical
Drive).
Replacing the Memory
Module(s)).
Replacing the Base
Cover).
Battery).