Removing The Palm Rest - Dell Studio 1450 Service Manual

Back to Contents Page
Palm Rest
Removing the Palm Rest
Replacing the Palm Rest
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
is not covered by your warranty.
CAUTION:
computer.
Removing the Palm Rest
1. Follow the instructions in
2. Remove any installed cards from the ExpressCard slot or the 8-in-1 Media Card Reader.
3. Remove the battery (see
4. Remove the base cover (see
5. Remove the hard drive (see
6. Remove any installed Mini-Cards (see
7. Remove the memory modules (see
8. Remove the keyboard (see
9. Turn the computer over.
10. Remove the ten screws from the base of the computer.
1 screws (10)
CAUTION:
NOTE: Make note of the cable routing before disconnecting the cables.
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
Before You Begin.
Removing the Battery).
Removing the Base Cover).
Removing the Hard Drive).
Removing the
Removing the Memory
Removing the Keyboard).
Pull on the plastic tab on top of the connectors to avoid damaging the connectors.
UserManuals.info
Mini-Card).
Module(s)).