Emerson Rosemount 3144P Reference Manual page 19

Reference Manual
00809-0100-4021
2.4.2 Typical European installation
Figure 2-7: Typical Remote-Mounted Configuration with Cable Glands
A. Cable gland
B. Shielded cable from sensor to transmitter
C. Shielded cable from transmitter to control room
D. 2-in. (50 mm) pipe
E. B4 mounting bracket
Procedure
1. Mount the thermowell to the process container wall.
2. Install and tighten thermowells.
3. Perform a leak check.
4. Attach a connection head to the thermowell.
5. Insert sensor into the thermowell and wire the sensor to the connection head.
6. Mount the transmitter to a 2-in. (50 mm) pipe or a panel using one of the optional
7. Attach cable glands to the shielded cable running from the connection head to the
8. Run the shielded cable from the opposite conduit entry on the transmitter back to
9. Insert shielded cable leads through the cable entries into the connection head/
10. Connect the shielded cable leads to the connection head terminals (located inside
2.4.3 Rosemount X-well installation
Rosemount X-well
intended for control or safety applications. It is available in the Rosemount 3144P
Temperature Transmitter in a factory assembled direct mount configuration with a
Rosemount 0085 Pipe Clamp Sensor. It cannot be used in a remote mount configuration.
Rosemount X-well Technology will only work as specified with factory supplied and
assembled Rosemount 0085 Pipe Clamp silver tipped single element sensor with an 80
mm extension length. It will not work as specified if used with other sensors. Installation
Reference Manual
The wiring diagram is located inside the connection head.
mounting brackets.
transmitter conduit entry.
the control room.
transmitter. Connect and tighten cable glands.
the connection head) and to the sensor wiring terminals (located inside the
transmitter housing).
™
Technology is for temperature monitoring applications and is not
A
B
C
Installation
December 2019
D
E
19