Panasonic KX-TDA50 Installation Manual page 132

3.2 Connection
External Modem Connection
Hybrid IP-PBX (9-pin)
Signal Name
RD (RXD)
SD (TXD)
ER (DTR)
DR (DSR)
After connecting the Hybrid IP-PBX and the external modem, set the power switch of the external modem
to "ON", then the external modem will be initialized with the default values.
The following AT command settings may be required for the modem:
• The Data Terminal Ready (DTR) signal should be ignored.
• The Data Terminal Equipment (DTE)/Modem flow control should be turned off.
• Data compression should be disabled.
• Error Correction is not necessary.
Notes
• Use an RS-232C straight cable for connection between the Hybrid IP-PBX and external modem.
• An AT command (for initialization, enabling automatic answer, etc.) can only be programmed by
KX-TDA50 Maintenance Console. "AT&F" is stored as the default value.
• For more information about the AT command, refer to the external modem's instructions.
132 Installation Manual
Great user manuals database on
RS-232C Port
(9-pin)
To CO line/Hybrid IP-PBX extension
port assigned as the CO line destination
Pin No.
2
3
4
6
UserManuals.info
Modem
To RS-232C port
(25-pin)
External Modem (25-pin)
Pin No. Signal Name
3 RD (RXD)
2 SD (TXD)
20 ER (DTR)
6 DR (DSR)