Applicable Controls - Toshiba RAV-HM301U1TP-E Installation Manual

Remote controller wiring
Strip off approx. 9 mm the wire to be connected.
Wiring diagram
Terminal block for
remote controller
wiring of indoor unit
Remote controller wire
(Locally procured)
Wiring on the ceiling panel
According to the Installation Manual of the ceiling panel, connect the connector (20P: White) of the ceiling panel to
the connector (CN510: White) on P.C. bwoard of the electrical control box.
31-EN
Terminal block
Remote
controller
unit
8

Applicable controls

• For using the wired remote controller RBC-AMS55E ,
refer to the Owner's Manual attached to the wired
remote controller.
REQUIREMENT
• When you use this air conditioner for the first time,
it takes approx. 5 minutes until the remote controller
becomes available after power-on.
This is normal.
<When power is turned on for the first time
after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Approx. 5 minutes
"SETTING" "SETTING"
Power on
fl ashes goes out
<When power is turned on for the second
(or later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Approx. 5 minutes
"SETTING" "SETTING"
Power on
fl ashes goes out
• Normal settings were made when the indoor unit
was shipped from factory.
Change the indoor unit settings as required.
• Use the wired remote controller to change the
settings.
* The settings cannot be changed using
the wireless remote controller, sub remote
controller, or remote controllerless system
(for central remote controller only).
Therefore, install the wired remote controller to
change the settings.
– 16 –
Applicable controls setup
(settings at the site)
Remote controller model name:
RBC-ASCU1
Basic procedure
Be sure to stop the air conditioner before making
settings.
(Change the setup while the air conditioner is not
working.)
CAUTION
Set only the Code No. shown in the following table:
Remote
Do NOT set any other Code No.
controller is
If a Code No. not listed is set, it may not be possible
available
to operate the air conditioner or other trouble with
the product may result.
Remote
controller is
available
1
Push and hold menu button and [
setting button simultaneously for
10 seconds or more.
After a while, the display fl ashes as shown in the
fi gure. "ALL" is displayed as indoor unit numbers
during initial communication immediately after
the power has been turned on.
Indoor UNIT No.
]
EN
32-EN