Table of Contents
Advertisement
Specifying the Desired Status Policies
Use these steps to specify the status policies.
1. Log on with administrative privileges to the first switch element, using a Telnet
connection.
login: admin
password: password
2. At the prompt, enter the
3. Specify the desired status policies.
NOTE: To completely deactivate the alarm for a particular condition, enter 0 at the prompt for
that condition and press the Enter key.
4. Repeat steps 1-3 for the remaining five switch elements in the SAN Integrated Switch.
Checking the Fabric for Port or ISL Issues
Use the islTopoShow command to make sure all switch elements in the SAN Integrated
Switch are displayed. For complete information on the islTopoShow Telnet command, enter
help islTopoShow from a Telnet prompt.
1. Log on with administrative privileges to the first switch element, using a Telnet
connection.
login: admin
password: password
NOTE: These are the only switch elements connected to every other switch element in the
group.
2. At the prompt, enter the islTopoShow command. This command provides general
information about all switch elements in the group. The following example shows a
fabric of 6 switch elements.
SW1:admin>
Switch ID
01
02
03
04
05
06
switchStatusPolicySet
islTopoShow
Domain
Worldwide Name
231
10:00:00:60:69:12:0a:b9
232
10:00:00:60:69:12:09:b0
233
10:00:00:60:69:12:09:c0
234
10:00:00:60:69:12:04:3d
235
10:00:00:60:69:12:09:77
236
10:00:00:60:69:12:0b:c7
Configuring the SAN Integrated Switch
command.
Name
SW1
SW2
SW3
SW4
SW5
SW6
3–9
Advertisement
Table of Contents
