Table of Contents
Advertisement
Garage Door Opener
1
1
While the car is ON, hold the handheld garage door transmitter 1-3 inches
from the HomeLink
button you want to program in the vehicle.
®
2
2
Push and hold both the HomeLink
button on the garage door transmitter.
TO ERASE ALL SET CHANNELS:
Push and hold the two outside HomeLink
orange indicator flashes. An individual channel cannot be erased.
button being programmed and the
®
buttons for 20 seconds until the
®
?
?
ROLLING OR NON-ROLLING?
Check your garage door opener motor in your garage for a
"LEARN" or "TRAIN" button by the hanging antenna. If you
have one of these, you have a Rolling Code garage door opener.
For Non-Rolling Code garage door openers, watch for the indicator
3
3
light to go constant.
For Rolling Code garage door openers, watch for the indicator light
to go from a slow blink to blinking rapidly.
4
4
For Rolling Code garage door openers only, firmly push and release
the "LEARN" or "TRAIN" button on your garage door opener
motor in your garage, then push the HomeLink
your vehicle for two long presses.
5
5
If the programming was successful, your garage door should
open and close with your chosen HomeLink
NEED ASSISTANCE?
1-800-355-3515
®
button in
®
button.
Scan For
HomeLink
®
Video
Advertisement
Table of Contents
