Service Air Piping - Sullair ShopTek ST4 User Manual

4: Installation

4.3 Service air piping

Before installing the compressor, review the service air
system's layout including: pipe sizes, auxiliary separator
tube, drip legs, line filter(s), and isolation valves (see Fig-
ure 4-3 on page 36).
36
ShopTek™ ST4, ST5, ST7, ST11, ST15 Three-phase 60 Hz User Manual
1. Sullair compressor
2. Sullair dryer
3. Shut-off gate valve
4. Sullair filter
Figure 4-3: Typical service air piping
88292018-236 R00
Subject to EAR, ECCN EAR99 and related export control restrictions.
Systems using both reciprocating and rotary
screw compressors must isolate the two types
from each other through the use of a common
receiver tank. Air lines from each individual com-
pressor should be connected directly to the com-
mon receiver tank.
5. Standard gate valve
6. By-pass gate valve
A1. Condensate drain
A2. Air outlets
NOTE