Yamaha R15 Owner's Manual page 25

Clock mode
1
ZAUE3351
1. Clock
The clock uses a 12-hour time system.
To set the clock
1. Switch the display to the clock
mode.
2. With the display in the clock
mode, push and hold the "SE-
LECT" and "RESET" button to-
gether.
3. When the hour digits start flash-
ing, use the "RESET" button to set
the hours.
4. Push the "SELECT" button and
the minutes will start flashing.
5. Use the "RESET" button to set the
minutes.
Instrument and control functions
6. Push the "SELECT" button to start
the clock.
Instantaneous fuel consumption
mode
L
1
ZAUE3352
1. Instantaneous fuel consumption display
Shows the current fuel consumption
when the vehicle is traveling at least 10
km/h.
There are two display modes: "km/L"
and "L/100 km"
To switch the instantaneous fuel con-
sumption display between "km/L" and
"L/100 km", push the "SELECT" but-
ton for one second.
 "km/L": The distance that can be
traveled on 1.0 L of fuel under the
current riding conditions is shown.
4-7
 "L/100 km": The amount of fuel
necessary to travel 100 km under
the current riding conditions is
shown.
TIP
 If traveling at speeds under 10
km/h, "_ _._" is displayed.
 The instantaneous fuel consump-
tion function should be used for
general reference only. Do not use
this figure to estimate the distance
that can be traveled on the current
tank of fuel.
Average fuel consumption mode
L
1
ZAUE3353
1. Average fuel consumption display
Show the average fuel consumption
since it was last reset.
4