Chilled Liquid Setpoint - York YCIV 0590-1500 50Hz Start-Up Checklist

If the following message appears when the STATUS
key is pressed, immediately contact YORK Product
Technical Support. The appearance of this mes-
sage indicates the chiller is a HIGH IPLV chiller
operating in STANDARD IPLV control.
UnIt WaRnIng: OPtImIzED EFFICIEnCY
DISaBLED – COntaCt YORk REPRESEntatIVE
Changing the programming of this
feature requires the date and time to be
set on the chiller prior to programming.
Additional information regarding this
message is provided in the ENABLING
HIGH IPLV MODE.
9. Program the required options into the Panel for the
desired operating requirements. Record the values
below:
Display Language = ______________________
Chilled Liquid Mode = ____________________
Local/Remote Mode = ____________________
Display Units = _________________________
Lead/Lag Control = _______________________
Remote Temperature Reset = _______________
Remote Current Reset = ___________________
Remote Sound Limit =_____________________
Low Ambient Cutout =_____________________
Damage to the chiller could result if the
options are improperly programmed.
8
PROgRammED VaLUES
10. Program the required operating values into the
micro for cutouts, safeties, etc. and record them in
the chart below.
Suction Press Cutout =
________________________ PSIG (kPa)
Low Ambient Cutout =
________________________ °F (°C)
Leaving Chilled Liquid Temp Cutout =
________________________ °F (°C)
Motor Current Limit =
________________________% FLA
Pulldown Current Limit Time =
________________________MIN
Suction Superheat Setpoint =
________________________°F (°C)
Remote Unit ID # =
___________________________
Sound Limit Setpoint =
__________________________%

CHILLED LIqUID SEtPOInt

11 Program the Chilled Liquid Setpoint/Range and
record:
Local Cooling Setpoint =
____________________ °F (°C)
Local Cooling Range =
_________ to _________ °F (°C)
Maximum Remote Temp Reset =
_________ to _________ °F (°C)
FORM 201.23-CL1 (309)
JOHNSON CONTROLS