Installation Instructions - Vulcan-Hart Snorkel SG-22 Installation Manual

INSTALLATION INSTRUCTIONS

This appliance when installed must be electrically
grounded in accordance with National Electrical Code
ANSI C1-1981.
Vulcan ovens are produced with the best possible
workmanship and material. Proper installation is vital
if best performance is to be achieved. Please follow
these instructions carefully.
1. Remove crating with care. Remove all wood
blocking, packing material and accessories.
2. Each unit is factory equipped and electrically con-
nected for use with type of gas and electric supply
indicated on rating plate behind the lower panel-
Check the type of gas and electric supply
available.
SG-2SMT AND SG-10SMT ADD-A-SECTION INSTRUCTIONS
PART A
PREPARING THE SG-2SMT UNIT FOR
STACKING.
(T in SMT indicates Top oven in double deck con-
vection oven. B in SMB indicates Bottom oven in
double deck convection oven)
TOOLS REQUIRED FOR THIS PROCEDURE:
6" adjustable wrench, 1/4" socket drive, 7/16" hex
head socket, 6" long 1/4" driver extension, 5/16" hex
head socket and flat head screwdriver.
1. Disconnect the unit from the gas and the power
supply and remove two rear lower aluminized ac-
cess panels. Remove panels using a 5/16" hex
head socket. Also remove S/S lower front cover. To
remove the front cover, slip a flat edged screwdriver
behind the panel and pop the panel off.
2. Using a 6" adjustable wrench and a 7/16" socket,
remove four screws (2 rear, 2 front) attaching the
leg stand to two burner insulation pans. Remove
and discard pans. (See Detail A)
7
3. SG-22 & SG-1010 units are shipped in two
sections with a 7" leg stand mounted on the
bottom unit. Position bottom unit as near to the
final location as possible.
4. Pipe joint compounds used when connecting ap-
pliances to gas should be resistant to the action of
propane gas.
5. Pipe joints should be tested for leaks with a soap
and water solution before operating the unit.
6. Mount the upper section on top of the lower sec-
tion from the front of units. Allow the upper section
to overhang the lower unit at the front by approx-
imately 8 inches. Refer to Detail A.
3. Using a 5/16" socket, remove the four bottom baffles
(2 front, 2 rear). (See Details B and C)