Table of Contents
Advertisement
Some chassis components may have sharp edges.
Special Note:
1. This section describes the disassembly procedures for all the
major printed circuit boards and main components.
2. Before the disassembly process was carried out, do take special
note that all safety precautions are to be carried out.
(Ensure that no AC power supply is connected during
disassembling.)
3. For assembly after operation checks or replacement, reverse the
respective procedures.
Special reassembly procedures are described only when required.
4. The Switch Regulator IC may have high temperature after
prolonged use.
Use caution when removing the top cabinet and avoid touching
heat sinks located in the unit.
5. Select items from the following index when checks or replacement
are required.
- Disassembling the Top Cabinet
- Disassembling the Front Panel
- Disassembling the Tray Assembly
- Disassembling the Rear Panel
- Disassembling the Mechanism Base Block
- Disassembling the FL & Head phone P.C.B.
- Disassembling the Main P.C.B.
- Disassembling the AC Inlet, Power & Sub power P.C.B.
- Disassembly of Digital Amp IC
- Disassembly of Digital Amp IC (IC5400)
- Disassembly of Regulator IC
- Disassembly of Switch Regulator IC
- isassembly of the Tray Base Guide (L) and Tray Base Guide (R)
- Disassembly of the Rotary Tray
- Disassembly of the Open Lock Gear
- Disassembly of the Close Lock Gear
- Disassembly of the Tray Motor P.C.B.and Sensor P.C.B.
- Disassembly of the Traverse Unit
26
Advertisement
Table of Contents
