Carrier WeatherMaker 50TCQ 17-24 Series Service And Maintenance Instructions page 28

7. Locate seal-tight assembly and secure it to the adapter. Snap
seal-tight into the smoke sensor.
8. Remove / -in. knockout plug in blower side plate. Refer to
7
8
Fig. 45 for location depending on the configuration of the
unit.
9. Snap seal-tight assembly into knockout hole.
10. Route seal-tight assembly to connector and complete con-
nection. See Fig. 45. Ensure seal-tight assembly does not
interfere with blower operation. Cut away any excess seal-
tight material.
11. Route 10 ft (3.05 m) cable through opening on lower right of
control box. Route with indoor fan wires securing cable to
wires with wire ties provided.
12. Route into sensor through knockout hole and plug end into
the RJ45 connector. Ensure knockout hole is sealed with
grommet mounted to cable.
13. Reinstall plastic cover.
14. Installation is now complete. Refer to "Sensor and Control-
ler" section for operation.
Fig. 44 — Return Air Detector Shipping Position
28
SAMPLE TUBE