Synthetic Vision Obstacles - Avidyne IFD550 Pilot's Manual

IFD500 Series Pilot Guide
datablocks in a narrow area on the right side of the display.
When configured to show datablocks, the datablocks overlay the
terrain and the SynVis view is re-centered in the available space.
To show the datablocks, touch the "Data" tab on the right side of
the display. Holding the left side of the SVS button will also
cause the datablocks to appear. To hide the datablocks, either
touch the "Data" tab to the left of the datablocks, or hold the right
side of the SVS button until they slide back off of the display.
The datablocks to be shown are configurable as described in the
Setup Page section, page 5-39. This is the same set of
datablocks that can be shown on the Map page.
SynVis with Datablocks

SYNTHETIC VISION OBSTACLES

Obstacles will be depicted in the SynVis scene out to 12nm.
Standard high, low and grouping symbology is used to depict
obstacles.
SVS Subsystem 2-7