Table of Contents
Advertisement
Installation and Configuration
Figure 12: Rear U-channel bracket screws
14. If additional options are going to be installed, remove the optional installation
Note:
SuperLoader needs to be removed.
18
brackets:
a. Remove the two screws securing each bracket to the front of the rack.
b. Pull the bracket forward and down, then push back to release the rear tabs.
c. Remove the rail from the rack.
Caution:
To avoid personal injury or damage to the equipment, be sure that
the optional installation brackets or other properly installed rack options are in
place below the SuperLoader at all times.
Be sure to save the optional installation brackets in a safe place for use if the
1/16 Tape SuperLoader Reference Guide
Advertisement
Table of Contents
