Table of Contents
Advertisement
7.
When the installation is complete, the TI-Navigator™ Setup dialog
displays the status of installed components.
You are now ready to set up your network.
8.
After pressing OK, you may be required to reboot your computer.
Setting up your TI-Navigator™ network the first
time
A Network Setup wizard helps you activate the access point and hubs for
wireless communication.
Note: See the warning statements on page viii.
Before you begin
1.
Make sure you have installed the TI-Navigator™ software on your
computer.
2.
Make sure each hub is fully charged (
3.
Remove the hubs from the charging bay. Each hub must have a
network connector attached.
LED is solid green).
11
Advertisement
Table of Contents
