Table of Contents
Advertisement
Finish the Installation
1.
Install the bath and drain (refer to the manufacturer's instructions).
2.
Connect the supply hoses to the water supply.
3.
Connect the drain body to the drain outlet.
4.
Make sure that the mixer lever is set in the off position (see User
Operation).
5.
Turn on the hot and cold water supply and check for leaks from both
the mixer.
6.
Remove the aerator from the spout.
7.
Turn on the mixer lever and push lever as far to the left (hot water) and
to the right (cold water) as possible, to remove any debris with a strong
flow of water. Check for leaks from both the mixer and the drain.
8.
Position the mixer lever to the off position.
9.
Re-install the aerator.
10. Connect the shower fittings to the outlet connector.
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.c
P4297070
16
P4297
Advertisement
Table of Contents
