Maintenance; Cleaning - U-Line 3000 Series User Manual & Service Manual

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS •

Cleaning

EXTERIOR CLEANING
Stainless Models
Stainless door panels and handles can discolor when
exposed to chlorine gas, pool chemicals, saltwater or
cleaners with bleach.
Keep your stainless unit looking new by cleaning with a
good quality all-in-one stainless steel cleaner and polish
monthly. For best results use Claire
Polish and Cleaner. Comparable products are acceptable.
Frequent cleaning will remove surface contamination that
could lead to rust. Some installations may require cleaning
weekly.
Do not clean with steel wool pads.
Do not use stainless steel cleaners or polishes on
any glass surfaces.
Clean any glass surfaces with a non-chlorine glass
cleaner.
Do not use cleaners not specifically intended for
stainless steel on stainless surfaces (this
includes glass, tile and counter cleaners).
If any surface discoloring or rusting appears, clean it
®
quickly with Bon-Ami or Barkeepers Friend Cleanser
a nonabrasive cloth. Always clean with the grain. Always
®
finish with Claire Stainless Steel Polish and Cleaner or
comparable product to prevent further problems.
Using abrasive pads such as ScotchBrite™ will
cause the graining in the stainless steel to
become blurred.
Rust not cleaned up promptly can penetrate the
surface of the stainless steel and complete
removal of the rust may not be possible.
®
Stainless Steel
®
and
Integrated Models
To clean integrated panels, use household cleaner per the
cabinet manufacturer's recommendations.
INTERIOR CLEANING
Disconnect electric current to the unit.
Clean the interior and all removed components using a
mild nonabrasive detergent and warm water solution
applied with a soft sponge or non-abrasive cloth.
Rinse the interior using a soft sponge and clean water.
Do not use any solvent-based or abrasive
cleaners. These types of cleaners may transfer taste to
the interior products and damage or discolor the lining.
CLEAR ICE MAKER CLEANING CYCLE
The 3000 series ice maker is equipped with an automatic
clean alert function. Cleaning cycles should be run as
notified. Otherwise, to maintain operational efficiency, the
unit should be cleaned every three months. Depending on
water conditions, more frequent cleaning may be
necessary. If the ice maker requires more frequent
cleaning, consult a plumber to test the water quality and
recommend appropriate treatment.
!
CAUTION
Wear rubber gloves and safety goggles and/or
face shield when handling Ice Machine Cleaner.
NOTICE
Discard all ice produced in the first harvest.
Should electricity to the unit be interrupted
during the self-clean cycle, the complete
cleaning cycle will repeat after electricity is
restored.
38
u-line.com
• SERVICE

MAINTENANCE

Cleaning 1