Exhaust Information; Electrical Requirements - GE GTDL200GMWW Installation Instructions Manual

ELECTRICAL CONNECTION INFORMATION
WARNING
RISK OF FIRE ELECTRICAL SHOCK AN
PERSONAL IN URY
O NOT USE AN EXTENSION COR
OR AN A APTER PLUG WITH THIS
APPLIANCE

ELECTRICAL REQUIREMENTS

T
20
I
WARNING
EQUIPPE WITH A THREE PRONG
GROUN ING PLUG FOR YOUR
PROTECTION AGAINST SHOCK HA AR
AN SHOUL BE PLUGGE
INTO A PROPERLY GROUN E THREE
PRONG RECEPTACLE
REMO E THE GROUN ING PRONG
FROM THIS PLUG
ENSURE PROPER GROUN EXISTS BEFORE USE
IF LOCAL CODES PERMIT,
AN EXTERNAL GROUND WIRE
(NOT PROVIDED), WHICH MEETS
LOCAL CODES, MAY BE ADDED
BY ATTACHING TO THE GREEN
GROUND SCREW ON THE REAR
OF THE DRYER, AND TO A GROUNDED
METAL COLD WATER PIPE OR OTHER
ESTABLISHED GROUND.
I
TO RE UCE THE
20 0H
THIS RYER IS
IRECTLY
O NOT CUT OR
I

EXHAUST INFORMATION

WARNING
UNITE STATES THE REQUIRE EXHAUST
UCT IAMETER IS
USE UCT LONGER THAN SPECIFIE IN THE
EXHAUST LENGTH TABLE
T
RESPONSIBILITY P
MAXIMUM ALLOWABLE
EXHAUST LENGTH
RECOMMENDED MAXIMUM LENGTH
Recommended
4" DIA.
4"
No. of 90° Rigid
Elbows Metal
0 150 Feet
1 135 Feet
2 125 Feet
3 115 Feet
4 105 Feet
95 Feet
5
EXHAUST SYSTEM CHECK LIST
HOO OR WALL CAP
SEPARATION OF TURNS
TURNS OTHER THAN 90º
IN CANA A AN IN THE
02 O NOT
YOUR
Exhaust Hood Types
Use only for short
run installations
4" DIA.
4" DIA.
2-1/2"
Rigid
Metal
125 Feet
115 Feet
105 Feet
95 Feet
85 Feet
75 Feet