Figure 19 library Cartridge
Slot Locations
Operating the Tape Library
The L200 holds one removable 6-cartridge magazine (see figure 19).
Slots are labeled 1 through 6 (the OCP recognizes these slots as
cartridges 0-5).
The remaining two slots (7 and 8) are fixed and internal (the OCP
recognizes these slots as 6 and 7). They are located behind the
removable magazine next to the internal drive.
Caution: Do not press the metal tabs on the left of the magazine.
Caution: To prevent cartridge jams, use the space on the front of the
cartridge for labels.
Note: Use physical slot 1 (OCP slot 0) when performing a drive microcode
update; use physical slot 8 (OCP slot 7) when using the optional
autoclean mode (see figure 19).
Note: Insert and remove all cartridges at the front of the magazine.
Note: The tape is write-protected if the orange indicator is visible.
The tape is write-enabled if the orange indicator is not visible.
Internal slots 7-8
(OCP slots 6-7)
Magazine slots 1-6
(OCP slots 0-5)
ATL PowerStor L200 Series Library User's Guide
Chapter 2 Installing the Cartridge Tape Library
Internal drive
Magazine handle
(open position)
Front panel
(open position)
Operating the Tape Library
OCP
25
2