After Using The Machine; Machine Long Inactivity; First Period Of Use; Maintenance - Viper AS4325B Instructions For Use Manual

INSTRUCTION FOR USE
Recovery water tank emptying
1. Stop the machine.
2. Lift the brush/pad-holder deck (M, Figure 8) and the
squeegee (L) by pressing the pedal (K).
3. Push the machine to the appointed disposal area.
4. Empty the recovery water tank with the hose (N, Figure
8). Then, rinse the recovery tank (C, Figure 10) with
clean water.
5. Remove the recovery tank lid (A, Figure 10) and clean
the inside of the cover and the filter floater grid (B) with
clean water.
6. Check the recovery tank (D, Figure 10) whether there is
foreign body jam and clean it.
CAUTION!
When draining the wastewater, the vacuum tube for waste must be folded (C, Figure 11) and
lowered to a lower position (D, Figure 11), and then open the lid of the vacuum tube for
waste to drain the water. Do not make the outlet of the vacuum tube for waste face upward
to drain the water vertically. This is to avoid wastewater spilling onto the operator.
7. Perform steps 1 to 4.
Solution/clean water tank emptying
8. Empty the solution tank with the outlet cover (E, Figure 11). After working, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brushes/pad-holders.
2. Empty the tanks (A and B, Figure 11) as shown in the previous paragraph.
3. Perform the daily maintenance procedures (see the Maintenance chapter).
4. Store the machine in a clean and dry place, with the brushes/ pad-holders and the squeegee lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the machine paragraph.
2. Disconnect the battery connector (B, Figure 3).

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and connecting parts for proper tightening and check the
visible parts for wear and leakage.

MAINTENANCE

WARNING!
Maintenance procedures must be performed after the machine is turned off and the battery
charger cable is disconnected. In addition, carefully read the safety chapters in the manual.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel or an authorized
Service Center. This manual only describes the general and common maintenance procedures.
A
B
Figure 11
18
ENGLISH
C
D
E