Table of Contents
Advertisement
Digital Radio/DAB Operations
3. When "PTY ITEM" is selected, PTY selection
is carried out. Operate the JOYSTICK § up-
ward or downward to select a desired PTY.
Press the ENT at the center of the JOYSTICK
§ to set the selected PTY ITEM.
(The PTY ITEM thus set is listed at the lower
right of the display.)
4. When "PRESET" is selected, PTY preset
memory can be called for and stored.
5. Operate the JOYSTICK § upward or down-
ward to select Preset Nos.1 to 6.
6. Press the ENT at the center of the JOYSTICK
§ to call for the preset PTY ITEM.
Press the ENT at the center of the JOYSTICK
§ for 2 seconds to store the PTY ITEM cur-
rently selected to any Preset No. selected
(listed at the lower right).
7. After adjustment is finished, operate the JOY-
STICK § rightward or leftward to move the
cursor to "MENU", and press the ENT at the
center of the JOYSTICK § to return to STAN-
DARD display.
Emergency broadcast
If an emergency broadcast is received, all the
function mode operations are stopped. "ALARM"
appears in the display and the emergency broad-
cast can be heard.
RDS interrupt does not function during AM radio
reception or in TV mode.
Cancelling an emergency broadcast
If you press the AF Button 7, emergency broad-
cast reception is cancelled.
Volume setting of TA, emergency
broadcast (ALARM), information
and PTY
The volume for TA, ALARM, information and PTY
interrupts can be set during TA, ALARM or PTY
interrupts.
The factory default setting is "15".
During a TA, ALARM or PTY interrupt, operate
the VOLUME button 2 upward or downward to
set the volume to the desired level (00 to 33).
When the TA, ALARM, information or PTY inter-
rupt ends, the volume returns to the level it had
before the interrupt.
38
VRX633R
Dynamic Label Function
A dynamic label (hereinafter referred to as "DLS")
is a text data associated with each DAB service.
This set can display DLS up to 128 characters in
a display.
This function is enabled only when the panel is
open.
DLS display mode
Press the TITLE button ¢ for 1 second or longer
to place in the DLS display mode. To cancel the
DLS mode and return to the previous display,
press the TITLE button ¢ again. If there is a DLS
data in the reception service, DLS text is dis-
played in the text displaying area.
Î
A mark "
" appears at the head of a whole text
sentence (page), and a RETURN mark is indi-
cated at the end point.
DLS memory
Up to six DLS, currently being received, can be
stored. By pressing the PRESET button # 1 to
6 for 2 seconds or longer, the DLS page currently
being displayed is stored. Operating the JOY-
STICK § rightward or leftward moves a cursor
to either P1 through P6, and pressing the ENT
at the center of the JOYSTICK § for 2 seconds
stores it.
DLS Calling
To call the DLS stored in the DLS memory, press
the PRESET button #. The DLS in the DLS
memory is displayed by 16 characters (2 lines)
at the intervals of 5 seconds (automatic calling).
To display at shorter intervals, press the PRE-
SET button # while waiting for successive DLS
character string to be displayed, the following
DLS character string is displayed (manual call-
ing).
With the DLS memory being called, move the cur-
sor to "UPDATE" and press the ENT at the cen-
ter of the JOYSTICK §. The display is changed
into the DLS display being received.
Advertisement
Table of Contents
